** Overview**

The normalized B-spline blending functions are defined recursively by

and if ,

where is a non-decreasing sequence of knots, and is the order of the curve.

These functions are difficult to calculate directly for a general knot sequence. However, if the knot sequence is uniform, it is quite straightforward to calculate these functions - and they have some suprising properties.

To get a pdf version of these notes look here.

** Calculating the Blending Functions using a Uniform
Knot Sequence**

Assume that
is a uniform knot
sequence, * i.e.,*
. This will simplify the
calculation of the blending functions, as .

** Blending Functions for k = 1**

if , then by using equation (1), we can write the normalized blending functions as

(3) |

These are shown together in the following figure, where we have plotted , , , and respectively, over five of the knots. Note the white circle at the end of the line where the functions value is . This represents the affect of the ``open-closed'' interval found in equation (1).

These functions have support (the region where the curve is nonzero) in an interval, with having support on . They are also clearly shifted versions of each other - e.g., is just shifted one unit to the right. In fact, we can write

** Blending Functions for k = 2**

If then can be written as a weighted sum of and by equation (2). This gives

This curve is shown in the following figure. The curve is piecewise linear, with support in the interval .

These functions are commonly referred to as ``hat'' functions and are used as blending functions in many linear interpolation problems.

Similarly, we can calculate to be

This curve is shown in the following figure, and it is easily seen to be a shifted version of .

Finally, we have that

which is shown in the following illustration.

These nonzero portion of these curves each cover the intervals spanned by three knots - e.g., spans the interval . The curves are piecewise linear, made up of two linear segments joined continuously.

Sinve the curves are shifted versions of each other, we can write

** Blending Functions for k = 3**

For the case , we again use equation (2) to obtain

and by nearly identical calculations,

These curves are shown in the following figure. They are clearly piecewise quadratic curves, each made up of three parabolic segments that are joined at the knot values (we have placed tick marks on the curves to show where they join).

The nonzero portion of these two curves each span the interval between four consecutive knots - e.g., the nonzero portion of spans the interval . Again, can be seen visually to be a shifted version of . (This fact can also be seen analytically by substituting for in the equation for .) We can write

** Blending Functions of Higher Orders**

It is not too difficult to conclude that the blending functions will be piecewise cubic functions. The support of will be the interval and each of the blending functions will be shifted versions of each other, allowing us to write

** Summary**

In the case of the uniform knot sequence, the blending functions are fairly easy to calculate, are shifted versions of each other, and have support over a simple interval determined by the knots. These characteristics are unique to the uniform blending functions.

For other special characteristics see the notes that describe writing the uniform blending functions as a convolution, and the notes that describe the two-scale relation for uniform B-splines

2000-11-28